Instrument Installation Bulk Materials

  • Instrument Installation Bulk Materials

    Posted by Chaitanya E on July 16, 2020 at 12:55 pm

    The selected compression tube fitting make shall be used throughout the whole installation. The
    compression fittings shall have 2 seal rings (twin ferrules).

    Pressure ratings for compression tubes, tube – and pipe fittings, instrument valves and manifolds shall
    comply with the corresponding process requirements.

    Tubing shall be seamless and shall be in metric sizes.

    Compression tube fitting threads: NPT
    Standard tubing sizes:

    Signal air, impulse tubing, instrument air supply to instruments
    and hydraulic supply (below 413 barg) = 10 x 1.5 mm

    Signal air, impulse tubing, instrument air supply to instruments and hydraulic supply (below 520 barg) = 10 x 2.0 mm

    Instrument air supply = 25 x 1.5 mm

    The Supplier shall use the standard tubing sizes and shall evaluate and advice if other outside
    diameters are required for any reason.

    Chaitanya E replied 3 years, 8 months ago 1 Member · 0 Replies
  • 0 Replies

Sorry, there were no replies found.

Log in to reply.