Automation Community
Automation Community

AO to AI Hart connection

  • PLC

    AO to AI Hart connection

    Posted by Mozer Nhambe on February 7, 2025 at 6:39 pm

    Good day guys, I want to connect a Siemens AO Hart signal to AI ABB (AI815) also Hart. I’m getting errors using regular connection type.

    How can it be done correctly ?

    Mozer Nhambe replied 2 months, 1 week ago 2 Members · 2 Replies
  • 2 Replies

  • Joseph Sirukhi

    Member
    February 7, 2025 at 7:30 pm

    Did you configure the module in control builder?

    If not please do check module configuration in control builder.

    • Mozer Nhambe

      Member
      February 7, 2025 at 11:18 pm

      By configuring the module what do you mean? I used the standard connection for ABB AI815 two wires. Using channel B and C, and in the control builder it’s already set for 4 to 20mA signal.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now
Share via

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .
Follow us and never miss an update!